$ 0.00

SpeedFactory Racing D16 SOHC VTEC Street Savage Camshaft

$ 376.19

****OFF-ROAD USE ONLY****

SpeedFactory Racing D16 SOHC VTEC Street Savage Camshaft - PN# SF-02-401

 

MUST BE INSTALLED BY A QUALIFIED AUTOMOTIVE MECHANIC OR TECHNICIAN.

IT IS THE END USERS RESPONSIBILITY TO CHECK ALL CLEARANCES FOR SAFETY AND VERIFY EMISSIONS LEGALITY IN YOUR APPLICATION.

Product Notes:

  • SpeedFactory Racing camshafts are designed and manufactured using new chill-cast blanks for superior wear characteristics and to eliminate any possible issues with post heat treatments etc.
  • Upgraded valve springs are required.
  • For optimal results camshaft must be degreed in with an adjustable cam gear.
  • Special Note: An adjustable cam gear is necessary to achieve correct camshaft timing in a D16Y8 setup.
  • Dyno tuning to achieve optimal results with your setup is highly recommended. Results will vary based on the quality and combination of parts used and tuning.
  • Improperly installed camshafts can cause catastrophic damage.
  • High performance camshafts put greater stress on valvetrain components which will cause higher wear rates.
  • Make sure followers are in good condition, any scuffing or scoring will result in accelerated lobe and rocker wear.
  • NEVER USE AN IMPACT GUN TO INSTALL THE CAM GEAR!!! Use a properly calibrated torque wrench and torque cam gear bolt to 23lb-ft. Use a small drop of removable thread locker like BLUE Loctite on the bolt.

Initial engine startup procedure after installation of your new camshaft is critical – the majority of all issues arise in this period and have to do with inadequate lubrication, improper valve lash, or the use of followers that are not in good condition.

  • Make sure followers are in excellent condition, any scuffing or scoring will result in accelerated lobe and rocker wear
  • Make sure the entire cam and followers have a liberal amount of quality assembly lube applied
  • DO NOT let the engine start without first cranking for oil pressure if it is a new engine or just had an oil filter change
  • Make sure valve lash has been set properly with the engine cold
  • Use a quality engine oil with high levels of ZDDP

SpeedFactory Racing D16 SOHC VTEC Street Savage Camshaft

  • Street/strip cam with excellent idle quality, faster spool, and increased midrange & top end power

INTAKE

Duration: 270*

EXHAUST

Duration: 256*

Valve Lash (cold): .007-.009” INT

Duration @ .050”: 241*

Valve Lash (cold): .009-.011” EXH

Duration @ .050”: 229*

 

Lift: .430”

 

Lift: .414”


Additional Info:

INTAKE

Opening: 10.5* BTDC

EXHAUST

Opening: 44.5* BBDC

Lobe Center:110*

Closing: 50.5* ABDC

Lobe Center:110*

Closing: 4.5* ATDC

*Valve timing is checked with zero lash @ 0.050” lift

PRODUCT DISCLAIMER

No warranty is stated or implied on performance camshafts due to the high levels of stress placed on them and the inability to monitor the conditions of their installation and use. If any camshaft proves to be defective for any reason, the purchaser assumes financial responsibility for any and all damages, repairs, or any other liabilities that may arise.