$ 0.00

JWT OBD1 B Series Standalone Engine Harness Kit with Switch Panel/Fuse Box

$ 1,050.00

****OFFROAD USE ONLY****

*Depending on availability, fuse box design subject to vary slighty

MADE IN THE U.S.A!

Our newly redesigned engine harness/switch panel/fuse box combo is now easier than ever to hook up and make a B series run on any chassis imaginable. These are mainly tailored towards our circle track customers but not limited to that. Select which alternator and injectors you will be utilizing in the drop-down box. If stock be sure to select whether OBD1 or OBD2, if using our FID lineup 1000cc and lower, choose the EV6. EV6 is common amongst many other injector brands as well. This kit utilizes a standalone switch panel/fuse box that plug and plays with the engine harness. Featuring a firewall disconnect, AUX1/Fan outputs integrated into the engine harness so you don’t have to route them from fuse box, fuel pump power/ground leads long enough to reach anywhere on the chassis, and AUX leads for additional switch. With this kit, you will only have to hook up a few wires manually to fire your car up and everything function as it should off the switch panel. Our engine harnesses are 100% quality tested pin to pin and resistance checked to ensure no voltage fluctuations. NO CORE is necessary when buying a harness from us!

This kit utilizes a base Rywire harness on the engine side. All connectors and materials are new. Each connector is crimped with pneumatic heads to ensure an OEM crimp every time, then tagged with a white identification label for easy installation. All heavy interference circuits are protected and grounded with proper wire covering. Our engine harnesses are 100% quality tested pin to pin; And resistance checked to ensure no voltage fluctuations.

All Rywire engine harnesses are made with OBD1 (92-95) computer connectors. A computer plug adapter can be used for OBD2 computers if necessary however our harness does not support USDM OBD2 computers. Aftermarket computers using OBD2 plugs and Non-US OBD2 computers are compatible (except for H22 and GSR stock computers).

***These engine harnesses are pre-built either ALL OBD1 or ALL OBD2. So if you have an OBD1 alternator but an OBD2 distributor, a jumper will be needed for the alternator or we can change the plug for you as it is only a single wire needed. Same can be done on the injector (if EV6 it is upcharge put we install new proper pins/plugs vs sending adapters for this option). Always order the harness around what distributor you have and let us know if the other plugs don't all match when ordering to ensure plug and play fitment when it arrives.***