Ecotec Balance Shaft Delete Tool
$ 64.99
*****OFFROAD USE ONLY*****
(1) Balance shaft delete tool used on Ecotec engines
This is a brief tutorial on how this tool works!
* With balance shafts removed, slide the driver tool into the block and you will feel the end of the tool touch the bearing. When holding a little pressure inward on the tool, it will self-center against the bearing, it is just a little recessed into its bore. It is best to use a heavier hammer, 2lb or so. Strike the tool with a decent amount of force, it will take a little bit to get it started. Continue to strike the tool until the stop barely touches the front of the block. Repeat these steps for the next balance shaft bearing and you are done. Any questions or concerns, call Bob Abbott at 217-430-5127 *